----------------------- The SA Boxes do not currently come with Owner's Manuals. (But this will be done in the future - so very busy here just now). Changing the SA4 Auxiliary Input is very easy: From Line In #4 to Record Out: 1) Disconnect the wires soldered to the Auxiliary Input RCA jacks. Put tape or heat shrink tubing on the ends of these unused Red and Blue colored wires to keep them from shorting out - but leave the other ends of the wires connected to the Selector Switch for possible future use. 2) Solder one 1K resistor to each of the Auxiliary RCA jacks. 3) Connect each 1K resistor to an Input on the stepped attenuator. 4) Mark the white colored Tape Out square on the back of the unit with a felt pen (to indicate that Auxiliary is now wired as Record Out.) Remember that the front panel Selector Switch is not usable when the Auxiliary Inputs are wired as Tape Outputs. I have attached some simple wiring diagrams (Acrobat) to illustrate this. Please let me know if there are any other questions. Regards, ----------------------- SAボックスのオーナーマニュアルは現在作ってないよ。 (でも、将来作るかもしれない。−ちょうど今、とても非常に忙しい) SA4の第4端子(AUX端子)の変更はとても簡単: 第4端子をレコードアウトにするには: 1)セレクタから第4端子につながっている線を取り去る。 切り取った赤と青の電線が他に短絡しないように、テープまたは熱収縮チューブを使って、電線の端に巻いて置いてください。 しかし、将来使用する可能性があるため、電線はセレクタスイッチに付いたままにしておいてください。 2)1kΩの抵抗を、第4端子の右左にそれぞれハンダ付けしてください。 3)アッテネータのInput端子と1kオームの抵抗を、それぞれ接続してください。 4)(第4端子が現在、レコードアウトであることを示すために)フェルトペンで筐体の裏側に印刷されているTape Outの欄にマークを付けてください。 第4端子をテープアウトとして使用しているとき、セレクタスイッチで選択できないことを思えておいてください。 これを図解した簡単な配線図(アクロバット)を付けました。 他の質問があれば、お知らせください。 よろしこ、